Results 11 to 16 of 16
Thread: 12mm axle to 15mm axle??
30-09-2008, 06:49 PM #11
Dont drill out the forks coz this will just make it weak and unsafe. I think you could get away with drilling the swinga but im not sure its worth doing. Easiest option would be to get some high tensile 12mm axel bolts to replace the existing china axle bolts and also get some decent bearings to go with it.If you can't explain it simply, you don't understand it well enough.
01-10-2008, 10:56 AM #12
You can do the swinger easily NO sweat .. just mark a straight line 1.5 mm further out from the stock axle slot top and bottom on the inside and outside of each side of it ... then carefully hand flat file it to the lines ... I've done quite a few for people ...
But the forks are risky and would need to be drilled using a drill press to get the holes square and parallel ... IF you marked them out the same inside and out either side (like the rear) , you could carefully (and tediously ) hand file them out with a round file to the marked lines ... BUT to avoid weakening the casting bosses ... (Depending on how they're configured) you'd have to move the holes down and back ... DO NOT touch the top or front of the original holes ... you want them to remain as thick as they are now ...
I told my relo the above advice about his forks (early DHZ gold forks) but as usual he didn't listen and took them to a machine shop where they outright flatly refused to do it for safety reasons ....
What you CAN do if you want to fit the better wheels with stronger straight pull spokes ... is buy 12 mm to 15 mm adaptor bushes ... That way you still use your 12 mm axles (or higher tensile one's) and spacers in a better wheel ... and leave your forks as strong as they are stock ...
Minimob Racing Kitaco Takegawa Trailbikes Mikuni Keihin SSR CRF50
01-10-2008, 11:07 AM #13
22-12-2009, 08:26 AM #14
take swinger to a machine shop to get milled
easiest/best way to do it
will cost anywhere from 30-100 depends how long it takes them to set the swing arm up square
22-12-2009, 08:33 AM #15
lol^^^ see the thread dates?09 CRF250R - fmf dual pipes, gieco sticker kit, cv4 hoses, vortex ignition.
08 Motovert pro - protapers, elka shock, marzoochi shivers, 125 daytona donk
My youtube channel:http://www.youtube.com/user/roost199?feature=mhee
22-12-2009, 08:36 AM #16
i thought it said 2009
way to early
may still be helpful to someone doing similar conversion
By spoonta68 in forum Tech TalkReplies: 7Last Post: 07-01-2009, 09:10 PM
By Pattyz in forum Tech TalkReplies: 3Last Post: 05-01-2009, 08:50 PM
By nafe in forum Tech TalkReplies: 3Last Post: 25-05-2008, 12:22 AM
By mr_mike in forum Tech TalkReplies: 7Last Post: 30-07-2007, 11:23 AM