Recent content by fauvelol

Yeah, id be changing the forks and rear suspension as i go. I was thinking about dropping the z160ho into it then adding mods, like a better carb, race head or bore to get it to 184 or yoshi because if the engine dies its relatively cheap to buy a new one and bolt everything back on. Just gotta...

Hey all, its been a while since i was active here as i sold my mini and purchased road bike for that legal goodness. I still have the addiction for minis so now that ive got some money behind me from working my ass off im considering doing a build and a thread when i have some days off from...

Yeah its 36/100, spot on. ill buy some from dhz on monday and throw them in and see how it goes. cheers.

quick question. any idea what the jetting should be in a oko 26 flat on a 150f anima? its pretty snappy down low but to get a smoother curve from mid to high what sizes would i be after? Im not even sure whats in it at the moment so i'll pop her out tomorrow and have a peek. but, as i read at...

finnaly got sent a proof for my graphics, cant wait. save a bit of coin to go into engine mods now I suppose ;) but yeah, the revs gradually get faster than the bike accelerating in high revs, it revs out and the bike very.. very slowly tries to match the rpms, so I let off the throttle so im...

/ new set of white plastics too, just waiting for my graphics kit to arrive. been watching a lot of tutorials so I dont **** it up lmao

Cut the bars back, cover and seat on. I'll get around to changing the front sprocket over, putting the new chain on and giving it a good clean. have to help a mate do a few tip trips tomorrow after uni :LAME: I'll post a pic my bike atm

done. already looks better. ordered a gpx seat and they sent me a pitsterpro labled one :p

nah. i dont haha. so its not needed? i can cut it off and just use it as a plug yeah?

is this needed or can I disconnect it and tuck it away?

was going to explain that a bit better after I installed my new bits... kind of ran into a problem..

I also fiddled with the idle and fuel screw.. god its so much quieter now.. i can actuallysomewhat talk over the engine but before it was deafening hahaha. Just want my stuff to arrive :beerchug:

Always a big help 67. After reading what you posted I adjusted it correctly today and its in working order, except the bike still slows proportionally after holding high revs for any amount of time in all gears as if I'm ever so softly feathering on the brakes or something, I don't know if its...

You're everywhere man hahah. I spent about 2-3 hours today loosening and tightening 3 nuts, very productive day. Isn't it supposed to roll freely in gear with the clutch in? Is there any certain position I'm supposed to have the bottom clutch cable lever in from the start? I put it on and pushed...

Hey all, I've been looking around the forums and can't seem to find a thread that has a similar problem to what I'm having, So I'm in the dark with this and decided to post. So I'll start off by saying my bike was running amazing until I snapped a tooth off my clutch gear behind the basket, I...