Recent content by Judge

Mini Dirt Bikes & Pit Bikes Forum

Help Support Mini Dirt Bikes & Pit Bikes Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. J

    yz 426f gearing

    Would two teeth make a difference an the front sprocket is enough i thought maybe id have to do both
  2. J

    yz 426f gearing

    Hi just wanted to get some advice on gearing i want to make it abit easier to be able to wheelue it in second or third gear i think i need to go down in teeth on the cogs i think would anyone know wat sprockets to use or how to work it out pls help would be much appreciated thanks
  3. J

    Yz426f Leaking fuel

    I was just wondering how do i measure the float level from wat point
  4. J

    Yz426f Leaking fuel

    Thanks buddy u was looking on eBay an there a manual that comes with the bike when u buy it but there a clymer one aswell would u know is there much of a differance between then witch would be better to get do u think
  5. J

    Yz426f Leaking fuel

    Yeah sweet how do u measure the float level an wat is the level suppose to be
  6. J

    Yz426f Leaking fuel

    I've got a yz426f an when it's just sitting there after riding if the fuel tap is still on fuel starts running out one of the over flow hose I don't think its normal but would anyone have an idea why or wat would be causing it
  7. J

    Yz426 valves

    Wat do I need todo shims as well can't u just adjust the valves like normal
  8. J

    Yz426 valves

    Can someone help me out with wat the valve clearance should be on a2000 yz426f
  9. J

    2000 yz426f removal an replace Steering stem bearings

    Yeah the bearings r ok but the top race has notche's in it I don't think u can just buy the race u have to buy the hole lot I think
  10. J

    Glowing exhaust

    Wat does it mean when u start a 160ho motor an after a minute or so the pipe near the header is glowing red it hadn't been started in around 6months I've started it its choughing an splattering wat could it be
  11. J

    2000 yz426f removal an replace Steering stem bearings

    Yeah true just wasn't to sure if I should buy them i was worried about damaging the frame I just wanted some opinions hopefully I'm not changing bearing to much
  12. J

    Bleeder screw on the lxr

    Thanks buddy is that the size of the screw on the lxr m4 .7mm pitch
  13. J

    Bleeder screw on the lxr

    I need some help with the fork bleeder screw on a nitro circus lxr my son has lost them does anyone know the size of them an the tread type I spoke to dhz they said they don't sell them so I'm going to have to buy a set of fork bleeders to replace them
  14. J

    2000 yz426f removal an replace Steering stem bearings

    Just need a bit of advise I need to change the bearings it's very notchy when turning them I was looking on eBay an they had some tools u can purchase when u buy the bearings this maybe a stupid question but r the tools necessary or can u get buy with chisels or screw driver to remove them an r...
  15. J

    Chain opinions

    Some times on a motocross track do a little bit of jumpingnot much but not to crash hot on the jumping side if it but mainly trail riding
Back
Top