Recent content by Red23

Mini Dirt Bikes & Pit Bikes Forum

Help Support Mini Dirt Bikes & Pit Bikes Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. R

    Lifan 125 rectifier?

    yeah I just checked the battery, with the engine stopped its 13.1v and with the engine running its 14.4 so the stator is charging just fine. When I apply the brake it spikes a bit but not to 12 (at the headlight that is) I'm just about to give up and send it to someone. I had two blokes at work...
  2. R

    Lifan 125 rectifier?

    well the new rectifier does nothing different. Would the first stator listed here have more output than the second or does it just look different for the same? I have the second type installed, just wondering if the first is higher output. Thanks again...
  3. R

    Lifan 125 rectifier?

    at this stage there is a vibration in the adapter plate somewhere, so its only about a solid 80 at this stage. With the 16T front and removing the vibration I reckon hitting 100 shouldn't be out of the question.
  4. R

    Lifan 125 rectifier?

    clearly my search terms were wrong lol. I need to punch myself in the ****
  5. R

    Lifan 125 rectifier?

    they're the only ones that sell a 428 pitch sprocket for the 125 (it has a 20mm shaft). I searched high and low before I found them, and so I ordered a couple of spares in different tooth count to try out, plus they are the only ones that specify the rectifier is for that motor. Everyone else...
  6. R

    Lifan 125 rectifier?

    I swapped the yellow/white wires around, and had no discernable effect. I've just bought myself a rectifier from dirt bike store and it specifies for the 1p54fmi and 12V. I think if this doesn't do the job I'm just going to downgrade the headlight to 6V and leave it at that. I'll check the...
  7. R

    Lifan 125 rectifier?

    thanks for the links, and sorry about the new thread I didn't think. The old rectifier wasn't doing anything, then with the ebay one it charged a flat battery but its not running the lights. After hardwiring the lights to the ignition it has drained the battery again, so its telling me the ebay...
  8. R

    Lifan 125 rectifier?

    Hi all I'm still having lighting issues with my postie. I've got the lifan via DHZ mini, its this one here http://www.dhz.com.au/buy/lifan-125cc-type-r-head-racing-engine-1p54fmi/EN-01 What rectifier should I be running? I bought a generic one off ebay and it charged my battery just fine...
  9. R

    lifan 125 not starting well?

    ok I've ordered a 20 slow jet and we'll see how that goes. Cheers all
  10. R

    lifan 125 not starting well?

    thanks guys, I might have a look, according to DHZ the pilot comes as a 15 standard. Where is the mixture screw? Is that the one at the bottom with the ?breather? hose? http://www.dhz.com.au/buy/mikuni-26mm-racing-carburetor-kit-90cc-110cc-125cc/CARB-001 when that screw is loosened it dribbles...
  11. R

    lifan 125 not starting well?

    thanks mate Its all brand new, I checked the plug when I got it (just having its 200km oil change) and its fresh oil. I'll have a look at the mixture. Had a little hiccup on the way home just then, a couple of pops occurred earlier today so I'm thinking maybe there is unburnt fuel etc? Maybe...
  12. R

    lifan 125 not starting well?

    Hi guys. Recently I installed a lifan 125 in my postie bike, and she runs/starts easily and no problems. Usually full choke, couple of twists of the throttle and second/third kick she starts and stays running. Now I can't get her to start, full choke couple of twists and she runs for a...
  13. R

    Postie bike conversion, lifan 125 help with wiring?

    So I just got my new stator from DHZ, before installing I chucked the multimeter on 200 Ohms, and put leads to the yellow and yellow, which gave me lots of variable readings, but only a solid 1 when a lead came off the wire, so I'm taking a punt and saying that this one works! I'll probably...
  14. R

    Postie bike conversion, lifan 125 help with wiring?

    nice one. He said he grinds the flange of a nut the same size (he's a mechanic, so he has spares) but I like the idea of high tensile washer. The other stuff is good too, I used a wedge on the original postie clutch basket. Can't do that here but I know a couple people with angle grinders so...
  15. R

    Postie bike conversion, lifan 125 help with wiring?

    Never thought of that, already on its way now. Apparently there is a trick to removing the flywheel and not damaging stuff. Gotta make a spacer so you don't mushroom the crank. Can do that but don't have a rattle gun. Wonder where I can borrow one of them from...
Back
Top