Search results

ok so i was riding today and i crashed my bike and it bent the shift lever rod.. not the actual shift lever but the rod tht comes out of the engine and has the splines on it for the shift lever... can anyone tell me how to bend it back because i dont have anymoney for a new engine.. any help...

actually what i found out was that the key on the crankshaft was missing and when i replaced it it ran just fine and i can rip the throttle no problem. i guess the backfiring was the magnet firing the sparkplug at the wrong time because the magnet didnt have anyhting holding it so it was...

i have an issue with my bike when i rip the throttle it bogs out.. this only happens when im in gear. and then when im in neutral and i rip the throttle it dosent bog out but sometimes with back fire.. and then when i release the throttle theres a noise that comes from i think the air filter but...

oh i gotcha haha allrighty thanks for the help! and yes i remember that i had to lock tight the nuts and bolts on my bike after it happened haha

Well it's not stuck in the magnet it's just Gone? Hah so imma buy a new one but how did you get yours in? Like did you use like a jb weld or rubber cement or do you just ram it in there??

Thanks do you know anything about like how much it would cost?? Like an estimate? Haha

Hey so I recently just bought a jap 90cc and when I was riding it a few days ago the stator nut that holds the magnet on the crankshaft fell off.. Well I didn't notice it fall off so I continued to ride.. When I was done I let my friend ride it aroun my block and the little like notch in the...