Search results

Hi Are exhaust and inlet valves rocker arms same? I did valve job and now there is alot of ticking noise from exhaust valve side. Valve clearance is set correctly but there seems to be a lot of horizontal play for the rocker arm on its shaft. Earlier or was perfect before tearing it apart. I...

Hi I have seen some cg replica engines which have builtin taps for oil cooler in its crankcase. Is it possible to mod a cg replica to have oil cooler? Regards Sent from my Nexus 5 using Tapatalk

Hi What is the Ideal engine operating Temps for liquid cooled cg clone engine 200cc Ohv. Mike stays at 80-100°C. Regards Sent from my Nexus 5 using Tapatalk

I had a Chinese 125cc ohv engine. It had some euro 2 standard device setup probably air suction valve thingy.. There was an air pipe going from the carburetor intake manifold insulator to that euro 2 device. I swapped the engine with a water cooled 200cc Ohv bit that engine doesn't have that...

Thanks will do it. And update of I see Amy improvements in using dc instead of ac Sent from my Nexus 5 using Tapatalk

Got it. This picture explains it. So there are three variations of kill switch. Either insert kill switch inline with the 12v feed to cdi, or ground the pulse coil output ( which is hardly 2 volts I think) or ground the Input to the coil (200 volts ac). I am a bit skeptical in inserting...

So that means to stop engine the pulser coil output should be grounded via kill switch button? Won't that cause sparking etc? As we are dumping the current from the pulser to ground. Also I searched few pinout pics of 4 pin cdi and they say switched 12v what does that mean? Sent from my...

I Googleed and wired this cdi and bikes starts. However how can I use a kill switch with it. Sent from my Nexus 5 using Tapatalk

Hi I have 6 pole stator. It's high tension coil for charging cdi is not working. I have replacement stator that has different number of coils but has same diameter thickness and mounting bolts. And physically fittable to bike. Can I use that? Sent from my Nexus 5 using Tapatalk

As mentioned I do have battery and rectifier already installed and working. Can I have the wiring diagram? Sent from my Nexus 5 using Tapatalk

Can someone help me wire it up? Sent from my Nexus 5 using Tapatalk

I do have battery and rectifier. Firstly I wanted to make sure that existing coil and cdi can be used. Secondly and most importantly I wanted to know if it's any better then ac cdi system? Sent from my Nexus 5 using Tapatalk

Hi have few ignition coils lying around. How do I know which one is the best? How do I know it? Is there some value that determines it? I am confused because one ignition coil for cHondaz 70 is having 0.6ohm primary coils resistance and 4.7K ohm for secondary winding. Another ignition coil...

Hi What is the count Relationship between the number of magnet poles on the rotor to the number of electrical coils. Say I have a rotor and a stator factory fitted in my engine and my stator has total 6 coils. One is for ac ignition 5 are for lightening. Doea installing an 11 pole stator...

Hi Oorcacing is selling 4 pin dc cdi and they have a video about how to convert 5 pin ac cdi to 4 pin dc cdi. Is it any good? anyone done it. Any performance gain or improvements? Also can we use same spark plugs and the ignition coil with this cdi? Or does dc cdi require different ignition...