Search results

You replaced the internal shaft? If so, check the whole way around the right side crankcase cover to confirm it's on properly and not leaking. I need to force mine down tight while installing the screws otherwise it leaves a small gap, not sure if that is common or not. Check around the...

Thought I would update this for anyone who might come across it when having their own problems. I believe the only problem with my bike was the spark plug cap not keeping a solid connection with the spark plug. Didn't do anything with the stator so the above numbers must be acceptable to get it...

The wiring must have changed over the years or perhaps mine is stuffed. (manual) Pick up coil: White/Red - Black : 18-22Ω (mine) same wires: 20.3Ω (manual) Charging coil: Black/Red - Black : 297-363Ω (mine) same wires: nothing. Black/Red - White : 301Ω (manual) Lighting coil: White -...

I've had other posts on here about this bike but the basic story is that the bike ran (with other issues) and then after installing a new complete top end I can't get it to produce proper spark. I have rested the spark plug on the head and have seen what I would describe as a bright blue...

I tested it out yesterday and it idled in "run" with no issues. I had previously removed every part of the carb to clean it out so I probably had it adjusted wrong. I'm thinking that it was probably just the idle screw position being wrong. I should have sat on the bike rather than leaving it on...

Hi, I need some help with this old PW50 I'm trying to get running properly again. I had most of the bike pulled apart to replace both crank seals so maybe I've put something back incorrectly. After I warm it up it will idle in the "start" position with no problem but as soon as I switch...

Thanks. That's what I thought but I had mixed up the packaging they came in so just wanted to make sure it was correct.

Hi, can anyone confirm which is the upper/lower bearing race from looking at the attached photos? Cheers

Thanks for the info rumble. Took me a while to get back to it. I did a little bit more cleaning and then put it back together. There is a small filter that's inside the pet**** which was full of crap, I cleaned all that out. Put some mower fuel I had leftover in there today just to try...

Hello, I am trying to get a pw50 that's been sitting for roughly 8 years up and running. I have been reading a lot on forums and watching youtube videos as I am a complete beginner so I only have a basic idea of what to do but I just need to check a few things... Here is a before and after...