Atomik Moto X Battery Cradle

[Streetvision]

Well, i got my bike, i knew that that particular bike had some major design flaws but i went ahead and got one anyway.

The clutch cable broke but thats not an issue can always get another one, but the electric start... IT WORKS!! For some reason it works, It was actually the only thing on the bike i was expecting not to work.

Anyway my problem is this, the battery fits into the cradle just fine, but it is impossible for me to tighten the screw up, because with the battery in there its to wide. and i dont want to take it all off, so how would i best get cradle secure.

I dont really want to drill a hole into my frame. it's out by about 2-3 cm's

 

[stumbows]

Ok i had the same problem but i just did the screw up first the slid the battery in after.

 

[Hillz]

dam sounds like a heap of stuff'n around, i remember going through this a couple of times..

 

[Streetvision]

I finally got it down, with lots of fancy cable tie work

 

[Lil_powlesy]

Where is the cradle located mine didn't come with one as previously removed by last owner and want to replace