First pit bike build

[roostyamates]

Hey guys thought I would share this little build with you
So I'm picking up a 140 braaap frame with all stock braaap parts which is running a Lifan 125 motor that needs
-chain
-stator plate
-clutch cable
Not bad for $150 I don't think?
And whatever else I find needs replacing along the way

Just. a few questions what stator plate will fit this ? Will an eBay 125 stator fit such as this

Lifan Magneto Stator Plate 50cc 70cc 110cc 125cc Thumpstar Dirt Trail PIT Bikes | eBay

And also is there anyway to remove the fly wheel with out fly wheel pullers?

Here is the bike and also some extras with it

Sent from my iPhone using Tapatalk

 

[my67xr]

That stator is for electric start
This one will work on the Lifan 125- Magneto Stator 70cc 90cc 110cc 125cc PIT Dirt Bike Kick Start Plate Coil ATV | eBay


And no you will need a flywheel puller to take the flywheel off
They are pretty cheap, around $20, M27 x1mm L/H thread is what you need.

 

[emmo1980]

you have most likely done it by now anyway....... but flywheel pullers just make the job easy, you dont need one just undo the flywheel nut and tap the flyewheel with a rubber mallet while putting a little leverage on it with a screwdriver its on a tapered shaft and will come off easily. i have done this heaps of times its quicker than getting the puller out.

 

[my67xr]

Dont' take any flywheel's off by levering it, or tapping it with a rubber mallet or hammer etc etc
You damage the crank bearing's and can make the crankshaft run untrue (bend crank).