ok so I done my valve clearances on my atomik nitrous 150cc...now all of the sudden sicei done it i got oil leaking from the bottom tappet cover.... I haven't broken or over tighten anything,there was never oil here befor please any advice would be appreciated! is the bottom tappet mabey not correct clearance?
HELP!! atomik nitrous 150cc
- Thread starter tono18
- Start date
Help Support Mini Dirt Bikes & Pit Bikes Forum:
my67xr
Miniriders Legend and Master Spanner Spinning Mode
no, it could be the rubber o'ring wasn't sitting properly when you fitted the cover and done it up.
just take the cover off, put a rag under it to catch any drips, and check if the o'ring is sitting correctly.
you might notice it sitting off to one side maybe?
just take the cover off, put a rag under it to catch any drips, and check if the o'ring is sitting correctly.
you might notice it sitting off to one side maybe?
my67xr
Miniriders Legend and Master Spanner Spinning Mode
did you that the front head cover off by any chance, the one with 4x retaining nuts ?
