Any of you guys cutting your own paper gaskets. lm after a decent quality gasket paper for inlet manifold . Any good results with different papers and gauge thickness will help .
I use Paper & Cellulose Fiber Material .8mm (RM015) for the thin one's, and Non Asbestos Fiber Material 1mm (RMO22) for anything else like inlet manifold gasket's and side cover gasket's etc
I also have a large roll of Non Asbestos Fiber Material 1.6mm (RM023) for making Ford 4L intake manifold gasket's and other stuff.
It's made by Payen, and is Oil Jointing gasket pape , and i get it from Repco.
Most Bearing shop's sell it on a roll's too.
Use a decent box clutter like an Olfa Knife, a single edge razor blade and some decent hole punch's