Pro taper bars

[roostyamates]

hey guys just wondering if i would need to change anything on my bike (atomik nitrous 160) to fit pro taper xr50 bars?

 

[my67xr]

have a look at these pics,
you may have problems with your top clamps, they might bite into the curve where they sweep up ?

i reckon i have seen a few on here using the Pro Taper Tuckey Rocky SE bars ?
But i am not sure what rise they have ?

Measure the width of the clamp area on your bike before you buy them

 

[roostyamates]

thanks for the help mate, i can clamp them straight on which is good..

another question, do i need to get a new throttle cable to fit a 1/4 turn throttle or should this one fit?

 

[nicko451]

Installing a 1/4 turn will need a new cable!

 

[my67xr]

My Atomik Fuse had a 1/4 turn throttle standard, unless the op means a 1/8th turn ?
but yeah check if you need a longer inner cable to use it with too, or a cable with an angled end, bigger thread etc etc

this pic is of a Nitrous 1/4 turn throttle, the stock one that comes with the bike, same as my Fuses' throttle