valve clearance problem

Mini Dirt Bikes & Pit Bikes Forum

Help Support Mini Dirt Bikes & Pit Bikes Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

dunny29er

Well-Known Member
Joined
Sep 13, 2010
Messages
368
Reaction score
6
Location
Sydney, Northen Beaches
was doing my valve clearance but the nut that locks the clearance in place is stuck on the bolt, so if i wanna make it less clearance i cant screw it in because the nut it stopping me from going in further

any idea's how to gut the nut to come undone
 
Last edited:
usually if you loosen the nut and adjuster from the rocker you can screw it right out of the rocker then use a pair of pliers or put the sqaure end in the vice and try loosening it then refit
 
usually if you loosen the nut and adjuster from the rocker you can screw it right out of the rocker then use a pair of pliers or put the sqaure end in the vice and try loosening it then refit

thanks might try that tomorrow
 

Latest posts

Back
Top