Recent content by anarchist_ways

yeah, never had a problem with metho

i have never seen a % charge on ebay.au

i think it's the wordage mountain, i can smell it too....

surely a grommet would fix this? cheap & easy....

have a check, there is a rubber part where it goes in the carby, this can sometimes become loose, and when the cable goes taught to rev, it opens allowing in too much air, choking it out. could also be the ratio, in which case you start it, check the carb for a small screw. play with it at the...

shit that embedd didnt work; here paste this Australian travel maps, street directory, driving directions & aerial photographs - Whereis.com

hey not sure if anyone mentioned it but i know a decent trail, with a few jumps an a hillclimb; im in geelong, its a 45min travel for me in the beat up van. bamganie, IS a nat. park but the closest 2 towns have no cop shops and the geelong pigs don't go out there. i've seen a few out there...

normal gasket sealer is ok to use? ill try the 1.5 turns, not sure what its at at the moment!

i got a new 26mm carbie + inlet, and now when i pull the throttle down full bore it bogs down and almost dies! it used to mono or go instantly. is this too much fuel? im not sure which way to turn the jetting screw either so im kinda stuck! any help would be appreciated. cheers

mini mullishas bike is sweet :D

cheers i heard that ngk were the go wasnt sure tho. thanks for ur help guys :D

does anyone know the best plug (and number) for a 125cc lifan four stroke?

i finally repaired it. i took of the clutch cover beside the rear brake, pushed in the black seal on the clutch (in between the screw and the crank) then adjusted out the screw a fraction. the seal came loose, blowing out compression, and releasing oil onto the adjuster screw, making it loose...

yeah apparently a fair few people have had this problem, i will take some photos after work tommorrow and post them.

yeah i think it is crank mounted, do you know how to fix it? i heard something about clutch plates?