Latest activity

Okay, then I don't have an answer for you, sorry...

No, the shafts are different sizes. It would require a large hammer to do that!

Just out of curiosity, do you have the two pulleys reversed?

Did some testing: with the rear wheel lifted it performs as expected. The front end of the belt enlarges and the read gets smaller; but...

Ive had a set of ct200u's for a year and they are a blast. Last week I put on an Amazon torque converter and changed the crank from 16mm...

The problem was due to a too big throttle free play. Adjusted the upper cable to have ~2mm free play and everything is as it should now.

I have a yx140 engine, iv replaced the head and installed a z40 cam, done a top end . Timing and valve clearances are intake .004...

Yeah, I already kind of checked that. The cable seems to be staying in the same place. Basically, it runs from the handlebars down under...

Check the routing of the throttle cable to make sure it isn't hanging up or binding on something when the bars are turned back and forth...

Hello everyone! Just bought my 5 year old daughter her first motorcycle - a Yamaha PW50 2018. Everything's fine and after 1-2h she's...

I have the same model. I’ve been wanting one for years. Finally was able to get it without pissing off the wife too bad.

Hello. I recently picked up a 2020 CT200U-EX V with stage 2 upgrades.

Hi There Does anybody know where I can find a dax clone (skyteam, icebear, triton, you name it 50, 70, 125) new or used? I am in the UK...

Ouch mate The 1P60FMJ is on both yx150 and yx160 basically the same as each other just different bore and stroke I believe it may also...

Hi. Does anyone have a wiring diagram for the DS80? Thanks in advance.