Recent content by kittybum

Thanks, Yeah I was just looking at the specs on DNM's page. I also see that you can buy these shocks cheap from MSO. MSO Pricing ========= MT-RC $180 MT-HRC $190 Does anyone know if the shocks with the tanks on them will fit on a provert, or will they touch on something? Any opinions...

Ok, my rear shock on my 06 provert is busted. I think I will get a DNM MST-BAG Just wanna know what everyone's opinion is on his shock. And what is the difference between this shock and the one linked below (besides the price and the Remote Reservoir) thanks. Genuine DNM Rear Shock...

Ill have another look thorugh some posts. The carby is a Mikuni.

I bought a new 140cc lifan engine and was running the 25mm carby on it, it ran fine but i thiought I better get a bigger carby. So I bought a 30mm carby. Now the enigne starts ok, and will rev up if i slowly apply the throttle, but if i slam the throttle open from idle it bogs down and stalls...

Yeah that's what I'm guessing. But the tube is a bit larger so it may have to be flattened a little so it doesn't rub against the shock.

hmm, im not sure that it will fit... there is no way i can get it in there with the back shock on. Ill take it off and see if I can get it to fit.

Hi guys, I bought a H-Bomb exhaust for my 06 provert and it doesn't fit as the provert has a perimeter style frame. I am going to bend the exhaust and was just wondering if anyone has done this before. If so, how did you go about it? Did you run it through the frame, or did you bend it...

ok thanks, How about the oil cooler? where does it connect to? I'm thinking the it could be the bolt on the clutch case, and the other one is just next to it on the engine... is this right? could really so with a manual

why is that?

Hi, I have an 06 provert and I have just purchased a 138cc lifan from DHZ and have some questions regarding installation. I have the new engine mounted but I don't know how to connect the oil cooler. I haven't connected a new clutch cable yet, but when I put the engine in gear and push the...

3rd gear has gone on my 06 provert 125cc. I want to put a 140cc engine in and I have a few questions. 1. I have been looking at the Lifan 140cc on ebay but I see there are some advertised as Lifan 140cc and others as the 'outlaw' are these the same engines? 2. Would I need a new...

The rear brake on my mojo provert is broken, I think it might be the master cylinder but I want to change the whole unit. Should I buy a provert original part or are there other options? Are there other ones that will match the same bolt patterns? Thanks

Thanks, Ill try get a pic ASAP.

Hey, Looking at buying an 06 provert 8months old. These bikes anygood? How do they compare to the new motovert bikes? What would be the equivalent current motovert model? And how much would you pay for one? Thanks.