Recent content by zpitfighter

alright here is the down low, bought a complete new harness, put it on...same results, it still has the old coil on it, I really don't think putting the new one on is going to make much of a difference, considering they had almost the same readings on the multi-tester. Yes fuel was drained...

can't be that^^^^brand new carb, and fuel line hahaha. Im just going to replace the the stator and harness Edit: I went out and bought a gear puller today at the auto parts store, Ima get that flywheel off later and order the parts

Im getting readings I forget the exact readings but when set to 200ohms it comes out 98, and 2kohms on the other wire on it comes out 380 I forget the exact wires....its some where in the thread....honestly I know its electrical and I'm tire of screwing with every thing, its a 5yr old bike, I'ma...

how would I go about contacting Terry?

you can get them a lot cheaper on ebay if you look, I picked my cdi up for like 8shipped

all right, well I don't have a flywheel removal tool so Ima need to figure out how to get to the stator, and how to find a wiring harness for it cause you can't just really walk into radio shack and get one that will be a perfect fit hahahaha.

alright so I need to get this thing finished within the week because I am leaving for college.......ughhh. What would make the bike start up and run fine and then die and not start at all I'm confused and just tired of this thing hahahahaha

stator plate was tested and the numbers came out fine, I posted the numbers a couple of posts ago, I know what you mean, I have never had this much trouble with any type of engine before hahaha

I already replaced them but Ill have a look see at it

alrighty so were back to it not firing at all, I will test the connections again tomorrow

hahaha^^^this thing has been trouble ever since I got it, Ill try again tomorrow, ill make some adjustments to the idle, and fuel and air screw and see what I can get. ugh hahahaha, Ill make a video of what its doing so you guys can give your two cents hahaha

ok, so its back to being stupid again, when I got it started earlier, I flipped the kill switch on and off and it turned on so I figured it was something in the kill switch wrong, so I cut the lines because there is no unplug on the bike and now its doing something different, ill take a vid...

alrighty the harness has been replaced, I got it to start up and rev up, but stupid me had the gas turn off on the carb, so once it cools down ill go out and get it started up again!

I will post a video tomorrow when I hopefully get it running, Im just going to replace the plug that plugs into the stator coming from the cdi, I'm not going to mess with trying to replace the terminals in the current one, might as well just replace it. I will post a video when I get it running!

ok so your talking about the connector coming from the stator, to the connector going to the connector at the cdi. alright will test and see, hopefully I can replace the terminals and all will be good hahaha