Search results

It's a rubber seal. I will soak it and see if any life comes back. The bowl has raised spots which prevent it from being lapped. I can check it over with a straight edge. Great ideas!

Might be the wrong place for that!:banana:

It's an older carb and the float bowl gasket is now rock solid. Maybe I can just find the gasket and not the whole kit, but I have not checked on that. Again thanks for all your help guys!

I'm just assume that this carb is a better platform then the stock 26mm Molkt? since I will probably spend more on a rebuild kit and jets then just getting a $30 Molkt. Thanks again guys! this really helps.

umm, did a little more research and stock is 95 main and 38 pilot. I thought there was a 1 in front of that 95 I guess. So should I just try it as is?

Thanks! I will get a set in that range, or I might even solder and drill until I find a good size. What do you think about a pilot? or is the main going to be the starting point. As this does have a needle to idle adjustment mixture.

I'm going to get a XY140 engine but I already have a 26mm Keihin off of a ATC200. I'm wondering if it will even work and where to start on jet sizing? I know this kind of thing has been beaten to death but this carb is not one of the normal ones that gets put on here correct? Stock, the...