Recent content by brown-i

yeah good earths, im guessing the wiring system i would need to do is the bottom one?

i bought a motor with a standard rotor, i wired it all up how my old motor was done but im not getting any spark? from the rotor there is red/black,white,blue/white,yellow and the earth. i thought it was from the coil yellow/black to the yellow from the rotor then red/blacks from the rotor...

haha can anyone get me one by tomorrow?

i havnt had time to pull the ingine apart but i have put a little fuel in the chamber, no go so i put a little start ya bastard in, no go. ill grab another spark plug tomorrow and see how that goes but ugh i might have to pull it apart. is it hard? i also took a pic of my wiring just incase...

haha good one, but yes everything is the way it should be and its just not starting:(

gday i replaced my 125 with a 140cc lifan, it was sittin for a good month before i put it in my bike. ive checked all my wiring twice, cleaned the carby, new spark plug, new oil, new fuel and it still wont start..whhhyyyy!

gasket gone?

did you go through all the nuts and bolts even before you rode it and tighten and locktite them all up?

will that work with the new cdi unit though?

oh stock flywheel and stator sorry

yeah change the fuel, fuel usually keeps for about a week i think. how about a new spark plug and coil?

ohhhhh, so yeah trying to wire new cdi to old irk dosnt work?that sucks then.

alright i bought a new cdi and irk for my older 125 motor but i wanna see if my newer 140 motor runs tonight, i dunno where my old cdi unit is so how do i wire up a newer cdi to a plain old irk? coloured wires are: irk-yellow, green with red stripe, white, black with red stripe, blue with...

yeah is is sort of a clearing then a line of trees with a few single tracks heading inot them? i wanna check that out to

it fits, but its like the teeth are further apart or something. i bought a 428 just havent tested it yet