Recent content by gonetopilbara

Hi all, Zongshen promised me 3 months ago they would send a service manual to suit a ZS155 engine. Does anyone have one? Why are they soo hard to get? Surely they make one or are they just decades behind like the Japs were many moons ago? Any help would be much appreciated.

#15 pilot and 95 main jet if that helps??? It used to run fine

Hi all, I have moved the clip on the needle up and this has actually componded the problem further. I have made a recording of it. The best way I could describe the noise is it sounds like it either drowning or sucking air, but can't see anywhere it could be. The audio is stored at...

moved the need up 2 (was on bottom). Still same issue. Will try higher (2 more notches left on needle) Nothing else it could be that you can think of?

I have set both valve clearances to .003 as they have not been touches since the bikes were purchased 2 years ago (not much riding time though) I just read the exhaust should be .004 Would this make all the difference? I am assuming (the mother of all you know what ups) that the air...

Hi all, at the risk of being shot down in flames for asking a question that may have been asked already (Yes I did search Google and the forums) I have a PitPro 125 fitted with the standard Mikuni Carb. It has been stripped down and cleaned. It is running rich (evidence of black...

Moving to WA and definitely interested in an orgaised group in a legal riding area. Please keep in touch. Also look at SAMBRA in South Aus, think they might be what you are trying to do.

I have no idea if this applies or is relevant to the small size of pitbike wheels, but on our motocross bikes we used to cable tie each of the spokes where they crossed over.

Hi Guys, I am about to make this stand so I will let you know how it goes. All instructions are in the pdf file in the link below. It is only 146kb but too large to attach in this post. Free File Hosting Made Simple - MediaFire From the look of the stand construction you could simply...

No worries, No offence taken. Will definitely go to SAMBRA. Just got some safety gear from the guys at Total Imports and waiting for the pressure suits to come in. They assure me it is fine and no problem to bring the kids as I was a bit unsure as they have never ridden and obviously not at...

Wow Mcanix Hi, Sorry if I appear to have upset you. I have no problem joining SAMBRA with my 2 kids and paying membership costs and helping out with maintaining the track. Yes I used to race and understand the costs of the Jap bikes and racing and helping out. As it turns out you...

Flarry, there is nothing at all wrong with SAMBRA, I just think another track would be great. After all, when you look at Motocross, speedway, etc, they all have more than one club and interclub meets, etc.

Hi everyone, If you are from South Australia and interested in a purpose built riding facility in South Australia please visit the petition link by clicking the link below Pitbike riding area Petition At this stage the only LEGAL known riding areas are JAMS and SAMBRA Motorcycling...

Ride on the roads????? Please dont tell me you ride on public bitumen roads? Because if you do ride illegally, you are just what we don't need another one of:mad: If I got this wrong and its a private road then my apologies. I am sure this will cause debate among you all, but the more...

Could any South Australian Pitbikers that are interested in pursuing the idea of starting a club and getting some land to ride on please PM me or emails me [email protected] I do know of SAMBRA and they have done a top job, but surely another riding area and club that could work in...