It's a rubber seal. I will soak it and see if any life comes back. The bowl has raised spots which prevent it from being lapped. I can check it over with a straight edge.
Great ideas!
It's an older carb and the float bowl gasket is now rock solid. Maybe I can just find the gasket and not the whole kit, but I have not checked on that.
Again thanks for all your help guys!
I'm just assume that this carb is a better platform then the stock 26mm Molkt? since I will probably spend more on a rebuild kit and jets then just getting a $30 Molkt.
Thanks again guys! this really helps.
Thanks!
I will get a set in that range, or I might even solder and drill until I find a good size. What do you think about a pilot? or is the main going to be the starting point. As this does have a needle to idle adjustment mixture.
I'm going to get a XY140 engine but I already have a 26mm Keihin off of a ATC200.
I'm wondering if it will even work and where to start on jet sizing? I know this kind of thing has been beaten to death but this carb is not one of the normal ones that gets put on here correct?
Stock, the...