can someone help me wire up my pitty?

[aaron.blake]

ok the pics are as follows

cdi with
2 x green
1 x yellow + white
1 x red + white
1 x white

coil
1 x green
1 x black + white

engine
1 x white
1 x black

kill switch
1 x green
1 x black

so yeah can someone help me to wire it up?
your help would be much appreciated

cheers aaron

 

[I_THUMP]

Hooper Imports Experts on Chinese Motorcycles and Parts

Try that site

 

[thump*140]

um, is that pics of wiring for an IRK?? looks bit messy.... try this...

 

[aaron.blake]

yeah that worked but the spark wasnt that strong is that because the bike hasnt been started in a while?

 

[thump*140]

nah that's just the usual IRK spark... they are pretty weak, especially if you have the pickup gap set too wide/ far apart... easiest way to set it, is to undo the two screws holding the pick-up magnet, slide a piece of normal a4 foolscap paper between the rotor and the pickup, then slide the pickup in a clockwise direction, until the pickup and rotor will hold the piece of paper without it falling out... loctite the two screws on the pickup and do em up tight... you will still have a weak spark, and it will take a stronger kick to start it, but if you have spark, it should be enough to get the bike running... good luck