installing new throttle cable..

[driftin_out]

hey i got a new braided throttle cable for my 125,
just wana no how do i put the cable into the carby?

 

[mattbombers]

*edit* hmm feel better now Sam?

 

[sam93]

Its easy mate no worries, heres a step by step instructions (sorry if i cant explain to well)
Step:
1. Take off the top cap of your carbie (where the throttle cable runs into)
2. Pull out the throttle cable (in the cable their will be a slide (the tube) the pin and spring.
3. Pull the spring back wards past the slide
4. push the cable forward and it should then come out (can be a lilttle tricky if you havnt done it before)
5. Get new throttle cable put it though the top cap
6. put the srping on the line
7. Put the line back into the slide at the bottom of the slide (where the pin comes out) youll see a little notch where the line sits in.
8. Pull back the spring again, and then release it so it goes back inside the slide.
9. Put the slide etc back into the carby
10. Put the top cap on.
11. Test the throttle make sure its working right. (if its not the slide isnt in the whole way their is a notch in the slide where its ment to go)

Then your done its pretty easy might sound complicated but youll get it dont worry, and you cant **** it so dont worry...you should understand how to put it back togetehr by taking it apart..
Hope taht helps if im wrong at explaining anyone please add their bit

 

[sam93]

thanks matt

 

[driftin_out]

yeah did it..and shes all sweet.
thanks for the info.

 

[sam93]

no problem mate