throttle not returning

[Frankie39]

i have a throttle with a mind of it own... it randomly reacts very slow to return when your revving the bike... dont notice it riding as my hand is usually on the throttle and its always returning but at idle revving it sometimes is slow to return. i have tried to adjust the tension, there is plenty of slack on the cable, is silicone spray an option? or am i just not doing something right?

 

[DvDRip]

cables need to be lubed, I use a cable lube adaptor ($10 at any bike shop) and chain lube. you can use engine oil and funnel it into the cable with a plastic bad if you wanna be oldskool and save $10 lol

also take your throttle tube off the bars and make sure it's not full of dirt, clean it up and grease it then when you put it back on make sure it's not tight against the bar end

also take your slide out of the carby and make sure the seal in the lid isn't tangled in the spring

 

[Frankie39]

you always have a good answer for me dvdrip! thanks... ill give it a try.
(still yet to figure out 100% the carby size, been to lazy to check lol)