Recent content by LOWLYF

i found the link about adjusting your valves, vary helpful vid! thanks

hey guys sorry i no this might sound stupid but what is your sig? do i need to change the cdi unit when i re wire the bike or just use the old stuff? I just put a new carby on it and it seemed to run a bit smoother but it didnt fix the problem. thanks guys

hey guys my bike is missing real bad, kinda stalling at about 1/2 to 3/4 rpm. if i stay into it it picks back up after 1 or 2 seconds and the nevs out ok. its making ok power still just doing the stalling thing. its a loncin 125 air cooled i have replaced the spark plug, filter,carby...

I got that wrong, the forks are the as-03 model, my origional axle is 12mm and the new axle is 15mm SORRY guys. Im gettin a tool maker to machine me up some bushes for the 10mm axle and bushes to go either side of the headset to make up for the difference in there. Iv been told to do this by...

yeah, bought them off an ebay store and the guy said they would fit. should have known better i guess. i just need to thread the pin 30mm further and cut the pin top off. i think that should sort it out. bearings and everything fit. it also has a 12mm axle and my 10" wheel has a 10mm axle...

Hey Guys, I have some fastace forks and the bolt that goes through the headset is too long for the neck of my frame by like 30mm. can i take this blot/pin out and replace with a smaller one? thanks Nick

Hey Guys Im pretty new to the pit bike thing, i got a 125 pitty 4 free it just needed a little clean up and its got a 125cc loncin motor in it. The guy i got it off never did any maintinance on this bike so with a good clean it came up pretty good. Saying that i think it could do with new...