Recent content by SwagOnWheels

yeah was gonna grab some start ya bastard from work and try. And spark is a blue. Doesnt really kick back and no doesnt puff back through the carby. not that ive noticed anyway. And the cdi is one of these ( eBay Australia: Buy new & used fashion, electronics & home d ) tried wiring it up...

yeah hasnt got an insane amount of compression but definitely has compression. Is a 125 lifan engine. And i did the clutch lose as i could and didnt make a difference. and nah has spark so shouldnt be anything to do with the wiring? And yeah got fuel coming out of the fuel line. but just seems...

yeah i thought so to but that was the only wheel i had lol. and havent got the money for a new one. And the old stator plate was snapped, Looked like chain had come off and broken it so thats why i bought the inner rotor kit. so nah it didnt run before i put them on.

Hi everyone, just giving you an update on my bike :) got few new parts, and few new issues with it :S. When i first started this project i started with the basic bits and pieces and have tried my best to assemble them all and get a running bike going! I got given a bike from a mate that was in...

yeah ended up cutting the bracket for the frame and drilled a new hole a bit higher. Tilted the engine away from the wheel and raised it a little :) may have been designed for 12/10 set up. but made a 14/14 set up work :) lol. sits about 20 - 30 mm higher.

yeah decided not to big wheel it. Bolted the engine in, wired it up almost all done, and realised needed new stator plate cause old one was cracked. also found out the engine hits the front wheel with only a 14"!!! any ideas how to fix that?

yeah alrieady measured them :) try and get some tomorrow! and get this bad boy in its hole haha. and yeah i thought i might have to. how much would a set of forks like that cost me?

also if anyone could tell me where to get some engine mount bolts from? be much appreciated :) and will i need extended forks if i want to put 17" wheel on the front?

Yeah thats not too much of a problem, :) i just hope when i put it together if it runs it doesnt blow a bunch of smoke or anything :S. Is it easier to assemble everything and then bolt in the engine mount bolts? or put the motor in and then everything else?

Yeah thought that much. ahwell just gotta hope for the best i guess! are they very hard to pull the heads off?

Hi everyone, I have been given one of my friends old bikes. which is in pieces and is missing a lot of them. ive got a rough idea of the parts needed and have bought them on ebay, some are decent quallity things like pro taper bars, and others ... Not so special such as a $3.00 airfilter lol...