I made this video showing how to replace the clutch in a Lifan /Yx pitbike engine.
Hope this helps some of you
<iframe width="560" height="315" src="https://www.youtube.com/embed/qlGE9eFMVT0" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen></iframe>
I made this video on replacing the head gasket on a 125 Lifan /YX motor
Hope this helps.
<iframe width="560" height="315" src="https://www.youtube.com/embed/f8L6N5DnFxA" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen></iframe>
Hey thumpers,
I put this video together about how too rebuild your Lfan / YX / pit bike carb
Hope this helps some of you.
<iframe width="560" height="315" src="https://www.youtube.com/embed/5Bqu379oISA" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen></iframe>
I would say coat the headgasket in some permatex copper spray, and re torque the head gasket after the engines first heat cycle.
Dont just go pound it off the bat, let it warm up and cool down once then re torque and you will be amazed how much the crush you lost on the gasket.
I go...
Checkout this video on rebuilding the clutch, it coveres the lock washers installation and how to tighten the basket but so it does not come off.
https://youtu.be/qlGE9eFMVT0