ok decided tp pull the case out and i could wobble the whole clutch and to what i saw there was like a locking nut that locks the clutch assembly onto a gear shaft was just floating around inside the clutch. so now my question is i pulled the little cover off the clutch and placed the locknut back onto the gear now do i do this up firm then back it off then close those little tabs over into the nut. (like car axles)
or do i just do it up tight with some loctite then fold tabs into it??
*Hi, I have the same problem at the moment with
my Lifan 125cc pit bike Clutch Locknut keep on comming
loose although I have tightened it properlu & bended those wings over
on the locknut washer. What else can I do? Any advise?