Engine case :/

[zippy168]

Where could I buy a new engine case left side, where one of the bolts go in
Through the magneto cover into to engine there's actually oil coming out of a bolt hole
But there's a crack that's split the actual casing

So really my question is where to find a case for that side?

 

[my67xr]

there are a heap on ebay.
you may want to pull the motor down and check that the gears are all ok too.
normally when a gear fails it will split the case

 

[zippy168]

The split is where the bolt goes in and the stator cover was cracked there to so whoever had the bike before must have hit it there with some force anyways I couldn't find any on eBay could you link me

 

[Shearer]

Mates crf50 is like this!
there 3 8mm bolts holding on ignation cover. top one longer then others. and if someone pots the longer top bolt in bottom right hole n tight'n up. busts though n oil comes outa hole when take bolt out again.

So if have to take cover off just lay bike on its side when got bolt out!
when pot bolt back in wount leck oil, as sounds like problem me mates got with his 50

 

[zippy168]

So leave the bolt in problem solved? But yes your exactly right with what's happening

 

[GooseMan]

what brand and size is the engine?
Also can people take more care in their replies so it is easier to read:hache:

 

[zippy168]

Honda stock 50cc

 

[Phil67]

permatex the bolt in, the non hardening one

P.S. I took only a little bit of care in this reply, hehe