J3NNINGS_024
Well-Known Member
hey people, just wondering if anyone has any tips or tricks for fitting a graphics kit to plastics?
cheers, brad
cheers, brad
Put them in the sun for a bit or use a hairdryer to heat them up, much easier to work with cause there so thick.
Theres also people that use a spray bottle with soapy water but i haven't tried that.
Good luck!
lol trueOh and don't stress, nobody will notice if they are not perfect, after all it is a dirtbike!
Soapy water works......
Spray plastics and the sticker, put them on, slide them around then just squeegie out the water. Let it sit for a day and done!
start with the longest straightest edge first. if you get that lined up the rest should go ok.
start from one side and work to the other, do no work around, you wont be able to get rid of creases. and I use a heat gun. when I have some crappy curves in the plastic, I use the gun to just heat up the vinyl and i can stretch it over the curve better. the adhesive will let you pull it up and do it a couple of times. just make sure that the plastic is super clean as well as your fingers. I use CRC Contact Cleaner to clean my plastics before puting stickers on.
Enter your email address to join: