SammyNiz-Nac
Well-Known Member
Hey eveyone, I put a bike together some time ago to slap around on and after a while later it started to wobble a bit? I checked over it a few times and found some play on my forks up/down in the headstem. So I loosend the top nut and tightend up the adjusting nut, it took up most of the play but when that seemed to be at the end of the thread it was still a little bit loose. I decided to pull the whole lot off to investigate and found that missing the bottom washer on the headstem.
Anyway here is where Im stuck, I need to remove the bottom bearing from the headstem bolt so I can put a washer there but Im not really sure how to without doing to much damage to the triples? not worried about the bearing cause I got some new ones.
Thanks
Sam
Anyway here is where Im stuck, I need to remove the bottom bearing from the headstem bolt so I can put a washer there but Im not really sure how to without doing to much damage to the triples? not worried about the bearing cause I got some new ones.
Thanks
Sam