FMX_22
Well-Known Member
Ok guys iv noticed a few people asking how to put graphics on there minis so i thought i would TRY and make a how to guide , i don't care if u do it differently this is how i do it and this seems to be the best way well i think that any way
ok so ill start
what you need
plastics. its best to use new plastics because they arnt faded and are clean .
butter knife
towel
hair dryer (or u can sit them in the sun for 5 min)
squirty bottle , put a bit of water and washing detergent in it (very important part)
N1
heat the graphics up with the hair dryer to soften them up a bit , it makes them easier to work with .
[/IMG]
N2 spray the plastics with washing detergent .
[/IMG]
N3 lay the graphics on to the plastics and start to line them up
[/IMG]
ok so ill start
what you need
plastics. its best to use new plastics because they arnt faded and are clean .
butter knife
towel
hair dryer (or u can sit them in the sun for 5 min)
squirty bottle , put a bit of water and washing detergent in it (very important part)
N1
heat the graphics up with the hair dryer to soften them up a bit , it makes them easier to work with .
N2 spray the plastics with washing detergent .
N3 lay the graphics on to the plastics and start to line them up
Last edited by a moderator: