New here so dont be to hard on me, if there is an OKO tuning thread, moderators please move my post there, Not Mini but of more importance is the tuning of my 30mm OKO.
Engine is a Chinese Honda based CG125, mods are, 150cc, 1mm bigger valves 25mm x 30mm, big cam, ported head, opened up pipe and 30mm OKO.
been playing with the settings and the best so far is needle in bottom groove, 42 pilot,95 main, air screw 1 turn out, I've tried different settings, this is the best so far,
without any load it revs freely, but under load its a bit sluggish mid range, which way should I be going?
Engine is a Chinese Honda based CG125, mods are, 150cc, 1mm bigger valves 25mm x 30mm, big cam, ported head, opened up pipe and 30mm OKO.
been playing with the settings and the best so far is needle in bottom groove, 42 pilot,95 main, air screw 1 turn out, I've tried different settings, this is the best so far,
without any load it revs freely, but under load its a bit sluggish mid range, which way should I be going?