Hi all. I have a 80's peewee I think but it's been running a bit sick under load. So I went to adjust the carbie and found what I think is the stock settings of about 2 turns out on the mixture and then turn that in or out till it idles really high and then fix it with the idle screw.
Any way after 30min I have cut my ankle and got fuel all in my cut and still have go no where :/
So can some one tell me what is going on and how I fix this. I'm going to pull the carbie off and clean it out and then try what ever some one post here.
If it helps there is a fair bit of fuel coming out of the over flow :/ I'm also running pre mix in the tank at about 35/1 and a modded pit bike air filter , no start run switch only a kill switch.
Any help would be good thanks
Any way after 30min I have cut my ankle and got fuel all in my cut and still have go no where :/
So can some one tell me what is going on and how I fix this. I'm going to pull the carbie off and clean it out and then try what ever some one post here.
If it helps there is a fair bit of fuel coming out of the over flow :/ I'm also running pre mix in the tank at about 35/1 and a modded pit bike air filter , no start run switch only a kill switch.
Any help would be good thanks