what setup are you running?: DHZ 6 piston brake setup, 4 piston front 2 piston rear. Running a 221mm front rotor on hand made capiler relocation bracket.
how did you set it up?: Got the 6 piston kit and found that it would not bolt up to my forks at all. Did the Tim Allen thing and decided to go the biggest rotor I could easily source (221mm). To make the relocation bracket I simply got some flat 6mm mild steel, cut the size piece that I wanted, drilled and tapped the holes where I wanted them. Placed the caliper with bracket onto the disk then measured the gap from the fork mounts to bracket and got a spacer that size.
problems that occured?: 221mm rotor is wave rotor and first bracket I made had the caliper sit out a little to far and was not using all the pads (ended up making a 221mm rotor out of cardboard to use when measuring). Remade the bracket and seems better. Have not yet looked at pads again but they do feel to be working better.
where did you source the parts?: DHZ (ebay)
full cost?: to bloody much..... probably around $150ish as you can't buy just the front kit so need to buy both to get the front caliper. Then you have the rotor, mild steel for bracket, correct size drill and tap, spacers, ect ect
pics: this bracket has yet to be trimmed down and painted but shows you an idea on how the bracket is made
