Too many revs!

[geezus18]

Hey guys,
I'm just wondering if anyone knows where the idiling screw is on a mikuni carb? If i turn the choke off the bike revs up and jumps into first then it builds its own revs and all i have to do is change gears...no throttle!!!
I cna take some pics of the carbie if that helps!

 

[Dabomb]

yes. the idle screw is on the right side of the carby, should be a phillips head..
Tightening the screw gives you higher idle..lower revs = screw it out.

The carby on choke dumps alot of fuel into the engine...this is normal...

cheeerss

 

[FLICK]

Edit: nevermind, too slow...

Edit: Manual: http://www.elstars.com.au/pdf/manual/mik-c25m.pdf

 

[geezus18]

ok cheers ill hav a look 2moro..is it just an odinary looking screw with a phillips head hole thing?

 

[geezus18]

Also i was wondering how you tighten up the front suspension? I think mine is too soft and when it gets near the bottom it hits the brake disc.

 

[Dirt Bikez & Pocket B]

neva heard of suspension hitting disk, do you have usd forks and what exactly is hitting the disk.

 

[geezus18]

That was only a guess but ill have a good look tomorrow.