got the special socket and took off the clutch rings. buffed the slug off and it works now. Now have to fix the front brake (out of fluid), adjust the carb (stalls out) and should be good to go...
they said it would never run so sold it for parts. drove it up and down my street..great...
I separated the plates with a screwdriver but have not taken the clutch assembly off. Once I get the special socket will take off and see.
I tried cranking up the tension cable but gets to a point can't even squeeze clutch lever (too hard). When the tension is cranked all the way and bike...
clutch doesn't work...
I increased the tension on the cable and nothing..
the bike has been sitting for a long time...
I just got it running but only in neutral.
clutch help (added youtube video)
Working on a cheetah 200 and clutch doesnt work. when I squeeze the clutch lever it moves just a little but wont engage the clutch. If i crank the tensioner still nothing.
I took the cover off and was going to take the clutch off and inspect but needed a...
I read the How To: Wire Your Bike (Kick Start) thread and had some more questions. I did post at end of the thread but did not hear back so posting here.
I have a Kazuma 200cc with a 6pin cdi. All the wiring has been removed and just want to use it as a dirt bike using the kick start. I dont...
I have a Kazuma 200cc with a 6pin cdi. All the wiring has been removed and just want to use it as a dirt bike using the kick start. I dont need lights,signals,horn. Can I use the same diagram? It does have two green wires coming out of the cdi. Can I just ground them?