cennyddpow
Member
- Joined
- Jan 1, 2012
- Messages
- 8
- Reaction score
- 0
I read the How To: Wire Your Bike (Kick Start) thread and had some more questions. I did post at end of the thread but did not hear back so posting here.
I have a Kazuma 200cc with a 6pin cdi. All the wiring has been removed and just want to use it as a dirt bike using the kick start. I dont need lights,signals,horn. Can I use the same diagram? It does have two green wires coming out of the cdi. Can I just ground them to the frame?
The coil had 1.2 ohms so I bought a new one but the new one is also 1.2 ohms. Is that the correct amount of ohms of 1.2? I thought it had to be 3 ohms or better.
I checked the ac voltage by connecting to the black/red and blue/white wire from the stator when I kick start it. It reads 60 volts. Can I assume the stator is good?
When I check the ohms reading on the cdi box I get readings on all points except the two green(negative/earth) point. Can I assume the cdi box is good?
Thanks for all your help
I have a Kazuma 200cc with a 6pin cdi. All the wiring has been removed and just want to use it as a dirt bike using the kick start. I dont need lights,signals,horn. Can I use the same diagram? It does have two green wires coming out of the cdi. Can I just ground them to the frame?
The coil had 1.2 ohms so I bought a new one but the new one is also 1.2 ohms. Is that the correct amount of ohms of 1.2? I thought it had to be 3 ohms or better.
I checked the ac voltage by connecting to the black/red and blue/white wire from the stator when I kick start it. It reads 60 volts. Can I assume the stator is good?
When I check the ohms reading on the cdi box I get readings on all points except the two green(negative/earth) point. Can I assume the cdi box is good?
Thanks for all your help
Attachments
Last edited: