I have a Daytona Anima engine that I am really struggling with.
Short story bought it as a 150cc and got it working pretty good, bought a 190 stoker kit and it wasn't working very good, put my 150cc back in...
NOW the problems:
It starts fine... but when I go past 1/2 throttle it starts cutting out, bogging, and generally runs like crap.
Wondering if it could be an ignition timing thing... my jetting is 38 pilot jet, 110 main jet on a PE28 Keihin carburetor at 5,300 ft elevation here in Colorado. I have the ignition advance set at position #3 and rev limiter at 13,500 which is what I had it at previously and it ran really good... especially at full throttle. I did try a 105 main jet prior because my plug was fouling and this seemed to fix the problem yet prior to that I was running a 110 and it ran superbly up to a point.
I have a race coming up this next weekend and I hope to be ready for action.
Thanks in advace for any all suggestions to trouble shoot and fit.
Short story bought it as a 150cc and got it working pretty good, bought a 190 stoker kit and it wasn't working very good, put my 150cc back in...
NOW the problems:
It starts fine... but when I go past 1/2 throttle it starts cutting out, bogging, and generally runs like crap.
Wondering if it could be an ignition timing thing... my jetting is 38 pilot jet, 110 main jet on a PE28 Keihin carburetor at 5,300 ft elevation here in Colorado. I have the ignition advance set at position #3 and rev limiter at 13,500 which is what I had it at previously and it ran really good... especially at full throttle. I did try a 105 main jet prior because my plug was fouling and this seemed to fix the problem yet prior to that I was running a 110 and it ran superbly up to a point.
I have a race coming up this next weekend and I hope to be ready for action.
Thanks in advace for any all suggestions to trouble shoot and fit.