l am shopping around for a lift up stand. standard mxs stands are 300mm (not extended) , cant slide under the bash plate . l most likely need something around the 250 mm (not extended) any links much appreciated . The braaaps a bit of a pig to lift on a bucket.
Help Support Mini Dirt Bikes & Pit Bikes Forum:
my67xr
Miniriders Legend and Master Spanner Spinning Mode
Did you see sheepys' stand build ? http://www.miniriders.com/mini-tuto...wn-motorcycle-lift-stand.html?highlight=stand
I only found that thread a week or 2 after making mine out of scrap steel, which reminds me i should paint it one day too.
Mine is about 240mm lowered, and 340mm raised
I only found that thread a week or 2 after making mine out of scrap steel, which reminds me i should paint it one day too.
Mine is about 240mm lowered, and 340mm raised
Last edited:
my67xr
Miniriders Legend and Master Spanner Spinning Mode
It wouldn't be hard, depending on what stand you buy
To lower a stand like this Motorcycle Jack Stand in Selby, VIC | eBay
If you trim the drop down leg that's connected to the top and drops over the base, so that when it's together again the top of the stand is 240mm or 250mm tall unextended.
Then you'll need to redrill the pivot bolt hole lower on the L/H side post of the stand so the lift arm doesn't hit your bike when lowered
To lower a stand like this Motorcycle Jack Stand in Selby, VIC | eBay
If you trim the drop down leg that's connected to the top and drops over the base, so that when it's together again the top of the stand is 240mm or 250mm tall unextended.
Then you'll need to redrill the pivot bolt hole lower on the L/H side post of the stand so the lift arm doesn't hit your bike when lowered
Last edited:
