ok well today i went to put sum new pro taper bars on my dhz.. all was going fine, untill it was time to put the throttle back onto the bars. i went to tighten it and no matter how hard i tighten the 2 screws on the throttle it is still loose on the bars,...
also i found that my old bars had a small hole in them and i little bit that stuck out on the throttle, the pro tapers did not so i just filed the little bit away on my throttle. was i ment to drill a hole in the pro tapers or is there another reason that my throttle wont go tight on my bars..
cheers
also i found that my old bars had a small hole in them and i little bit that stuck out on the throttle, the pro tapers did not so i just filed the little bit away on my throttle. was i ment to drill a hole in the pro tapers or is there another reason that my throttle wont go tight on my bars..
cheers