it's looking very good now brendo,
here is an idea for you,
Speedflow make some cheap anodised ends for hoses, most car speed shops sell them.
like these-
http://www.ebay.com.au/itm/Speedflo..._Parts_Accessories&hash=item2c6885e203&_uhb=1
http://stores.ebay.com.au/Torques-U-K/AN-6-12-5mm-and-15-mm-/_i.html?_fsub=1060567012
http://www.ebay.com.au/itm/Aluminiu..._Parts_Accessories&hash=item2ebfca2f73&_uhb=1
or you could put some banjo fittings on the ends-
http://www.ebay.com.au/sch/i.html?_...sacat=0&_from=R40&_nkw=banjo+hose+ends&_arr=1
i like the Cobra clamps, being stainless they are easily polished, and they are only about $2-$4 each.
you need to know the diameter of the hose when it is clamped up though to order them.
i buy a few maybe 12mm,13mm, and a 14mm and try them on,
i see which clamps the hose the best, then order more of that size.
they clip together firmly with some pliers, and are use for high pressure fuel injection systems etc.
to undo them you put a small flat blade screwdriver in the gap where they join and twist it to pop them open.
they are reusable a lot of times.
Pirtek and Enzed sell them, some Repco's keep them too.
these are the ones i used for my PWR trans cooler hoses on my Ford Territory,