yeah coil wiring looks ok, black w/yellow stripe to the positive terminal and green to earth.
except you mixture screw look to be turned in a lot more than 2 turns out ?
when you look down into the pilot jet, can you see light though it ?
there is a tiny hole that goes through into the bore of the carby,
remove the pilot jet, then pull the top off the carby, and take the slide out,
look down the slides' hole, you should be able to see the pin hole on the manifold side of where the slide sits,
this should be see through to where the pilot jet screws into underneath
also while the pilot is out, check you can see through it, and the smaller side holes on the other end